Wall thickness single point (WT)
1
votes
After setting the single point in the image, the WT button is deactivated again. If you want to set a lot of individual points, you have to activate the WT button again and again. This is complicated and takes time. It would be good if the WT button remained active until it was clicked again
Comments: 1
Oldest
•
Newest
•
Most likes
•
Fewest likes
-
03 Feb, '25
Nick D'Ademo AdminThanks for the suggestion Holger!
This is already possible by activating "Continuous Drawing Mode" - you can use the 'C' keyboard shortcut to quickly activate/deactivate this mode in the Workspace.